Keep Your LiPo Safe – Koswork KOS32310S & KOS32310XS LiPo Charging Cases
LiPo fires don’t give you much warning, and a standard bag or box isn’t built to contain one. A proper LiPo charging case is designed to keep the heat and flame inside if something goes wrong — not just protect the battery from bumps, but actually contain a fire event. Koswork makes two sizes, both built around that principle, both with fire retardant foam interiors, wire-through ports, and filtered ventilation holes that keep airflow controlled without letting a fire spread.
For Dual LiPo Charging and the Track: KOS32310S
The KOS32310S is the larger of the two, at 210×150×H125mm outside. It’s designed to charge two LiPo packs at the same time — two wire-through ports with covers handle the charging leads without leaving the lid open. The hard shell contains heat and flame in a fire event, the fire retardant foam protects the packs inside, and the filtered ventilation holes keep the case looking clean while managing airflow. Solid latch, carry handle, lightweight enough to pick up with one hand.
At the track, the KOS32310S doubles as a tire warmer station. The tire warmer controller and battery go inside the case, the car sits on top, and the warmers go on the tires. Pull them off when it’s time to line up. It’s one of those uses that sounds secondary but actually gets used constantly on race day.
Outside dimensions: 210×150×H125mm. Inside lower case: 195×135×H65mm. Inside upper case: 195×135×H35mm. Note: longer LiPo charge/balance leads are required.
Ultra-Compact for the Pit Bag: KOS32310XS
The KOS32310XS is the extra small version, designed specifically for compact storage and easy transportation. At 180×80×H100mm outside, it fits in a pit bag side pocket or anywhere you need a LiPo case without giving up significant space. Same fire containment design, same fire retardant foam, same filtered ventilation holes and wire-through ports with covers. Designed to allow dual LiPo charging at the same time with a maximum 80mm pack thickness. Solid latch, lightweight hard shell.
Outside dimensions: 180×80×H100mm. Inside lower case: 170×70×H55mm. Inside upper case: 170×70×H25mm. Note: longer LiPo charge/balance leads are required.
Both cases are available through your local Koswork dealer or authorized distributor worldwide.
